ENGLISH
The height should be 102.5 mm from the base of the wall charging base to the ground.
Make sure that the charging base is securely fixed on the wall, place the vacuum cleaner on
the charging base as shown in figure 5 by putting the vacuum cleaner's charging terminals
into contact with the charging base's ones (plastic tab).
Fig. 5
Once the wall charging base is installed, the charging port must be connected to the power
adapter, and then the device can be charged by sliding it from top to bottom into the wall
charging base.
Charge and display
When the battery percentage is 20 % or below, the device will automatically enter low
consumption mode. It is recommended to charge the device when it reaches this percentage.
The battery must be charged while it is inside the device, and on the fast charge base.
Connect one of the ends of the power adapter to the power supply and the other to the fast
charge base. During charging, the charge light indicator will turn on red and will turn green
once the charge is completed.
In order to charge only the battery, plug the power adapter and connect the other end of the
cord to the battery. During charging, the charge light indicator will turn on red and will turn
green once the charge is completed. The display will show the battery charge.
Fig. 6
Charging modes
Charging mode 1
Fig. 7
Fig. 8
Charging mode 2
Fig. 9
Charging mode 3
Fig. 10
How to use the handheld vacuum cleaner
Press the On/off button to turn the device on or off.
Press the speed control dial to select the device operating speed: Low, Medium, High or
Smart. The device will start operating at low speed by default, and the screen will display
"LOW". The battery percentage and sync will also be displayed.
Press the speed control dial to set the device at medium speed. "MED" will be displayed on
the screen. The battery percentage and sync will also be displayed. 2/3 of the opening radio
will be shown (vacuuming).
Press the speed control dial to set the device at high speed. "HIGH" will be displayed on the
38
ROCKSTAR 900 ULTIMATE ERGOWET
screen. The battery percentage and sync will also be displayed. The vacuuming opening
radious will be completely shown.
Press the speed control dial to set the device at Smart speed. Under this mode, the device will
automatically adjust suction power according to the concentration of dust and to the amount
of dust on the floor brush. "AUTO" will be displayed on the screen. The battery percentage and
sync will also be displayed. The screen will display: the amount of absorbed dust, 1/3 when
the concentration opening radious is low, 2/3 when the concentration opening radious is
medium and the full display when the concentration opening radious is high.
When operating at high speed and the battery is 20 % or lower, the device will automatically
switch to medium speed in order to lengthen the battery life.
Fig. 11
How to use the suction base for floors
It removes dust from carpets, hard and soft floors, and tiles.
If too many particles or fibres are vacuumed, or if a child touches the brush during operation
by accident, the rotary brush stops spinning automatically in order to prevent tangles and
possible damage.
Both brushes can be equally assembled to the suction base:
Best Friend Care brush
Removes pet hair from all types of surfaces, including carpets and mats.
Jalisco brush
Vacuum 3 times more dust in one pass. It is recommended to use it on hard floors, but it can
be used on soft ones too.
Fig. 12
Includes a 2-in-1 narrow accessory for corners and furniture
Includes a 2-in-1 narrow accessory for corners and furniture
Suitable for cleaning doors, windows, narrow corners, etc.
Fig. 13
Suitable for cleaning sofas, cabinets and wardrobes, windows, etc.
Fig. 14
Long brush
Fig. 15
Fig. 16
Suitable for cleaning surfaces which are sensible to scratches such as furniture, wardrobes,
etc.
Flexible hose
It can be assembled onto the device for a more flexible cleaning, to reach the most difficult
corners.
ENGLISH
ROCKSTAR 900 ULTIMATE ERGOWET
39