Connecting The Device To The Power Station Gx - Walimex Pro Power Station GX Mode D'emploi

6.2. Connecting the device to the Power Station GX

WARNING
Pay attention to the safety notes on page 28-32.
• Depending on the type of use you should set the mode switch on the
Power Station GX to continuous operation "Normal", e.g. when used with
a Daylight, or to flash operation "Flash".
• Connect the mains cables of the devices to be used to the jack on the
Power Station GX.
• Switch on the Power Station GX on with the On/Off switch.
• For use with USB-devices – Operate the On/Off switch to position II –
USB.
CAUTION
Ensure a correct USB socket for using or charging your device. DC 5V
2000 mA / DC 5V 1000 mA / DC 5V 500 mA. Read the operating instruc-
tions of the manufacturer of your device before use.
NOTE
You can either use the AC or the USB-function. Parallel use is not possible.
Battery status display
LED flickering red
LED light red
LED lights orange
LED lights geen
LED flickering orange
38
Powepack Power
<10.7 or >15.4 V
10.7 ~ 11.2V
11.2 ~ 12.3V
12.3~14.6V
14.6~15.4V