Axis Communications P13-E Serie Guide D'installation page 19

5. Also see Access the Product on page 19 to access the video stream
6. Attach the safety wire in the top cover to the tab in the bottom cover. See Hardware
Overview on page 10
7. Install the top cover. Make sure to tighten diagonally opposite bottom cover screws a few
turns at a time until all are tight. This will help ensure that the bottom cover cable gland
is compressed evenly. Do not attempt to tighten the screws completely the first time.
8. Install the cable cover and tighten the cable cover screws.
9. Loosen the sun screen adjustment screws and adjust the sunshield to the front position.
Connect the Cables
1. Optionally connect external input/output devices. See Connectors on page 15.
2. Connect the network cable to the network connector in the housing.
NO TICE TICE
NO NO TICE
Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required. Any
network cables that are routed outdoors or in demanding electrical environments shall be
shielded (STP) and intended for their specific use.
Cold Startup Delay Switch
The housing used in this Axis product features Arctic Temperature Control, which is enabled by
setting the Cold Startup Delay switch to I (ON). When enabled, this function controls when the
camera restarts after a power cut, when temperatures are below 0 °C (32 °F); the camera is first
heated to approximately 0 °C (32 °F) before it initializes. This prevents damage to camera models
that include moving parts.
Access the Product
Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup/
Adjust Focus
To adjust the zoom and focus follow these instructions:
Note
• Set focus as precisely as possible with the focus puller or Focus Assistant before starting
automatic fine tuning. Using the focus puller normally gives the best result.
• The iris should always be opened to its maximum while focusing. This gives the smallest
depth of field and thus the best conditions for correct focusing.
AXIS P13-E Network Camera Series
19