Axis Communications P13-E Serie Guide D'installation page 14

AXIS P13-E Network Camera Series
Note
The I/O connector is connected to the housing (fan/heater) on delivery. In the case of a fan
or heater error, an input signal will be triggered in the camera. Set up an action rule in the
camera to configure which action the signal shall trigger. For information about events and
action rules, see the User Manual available on www.axis.com
Audio Connector
The Axis product has the following audio connectors:
• Audio in (pink) – 3.5 mm input for a mono microphone, or a line-in mono signal.
• Audio out (green) – 3.5 mm output for audio (line level) that can be connected to
a public address (PA) system or an active speaker with a built-in amplifier. A stereo
connector must be used for audio out.
For audio in, the left channel is used from a stereo signal.
RS485/RS422 Connector
Two terminal blocks for RS485/RS422 serial interface used to control auxiliary equipment such
as PTZ devices.
SD Card Slot
A microSD card (not included) can be used for local recording with removable storage. For more
information, see Specifications on page 15.
NO TICE NO NO TICE TICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To
unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Note
For SD card recommendations see www.axis.com
Control Button
The control button is used for:
• Enabling the Focus Assistant. Press and very quickly release the Control button.
• Resetting the product to factory default settings. See page 21.
• Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic DNS
Service. For more information about these services, see the User Manual.
14