Muller Light 404013 Mode D'emploi page 71

Problem
I cannot add a bulb to a new
system.
I cannot add the bulb.
I have to press the standby button
several times.
Which group is my bulb in at the
moment?
Answers to other frequently asked questions, see
www.mueller-licht.de/tint
tint-STARTER SET
INSTRUCTION MANUAL
71
Possible causes
Please check whether the bulb is
in coupling mode.
The bulb is already assigned to
a remote control or a gateway.
Please remove it from the existing
network
Bring it closer to the remote
control
Switch off any nearby Zigbee
devices
If the bulb has previously been
switched off using the light
switch, the tint remote control will
have to resynchronise.
You have switched off parts of the
system using a light switch. The
tint remote control is resynchro-
nising.
Simply switching the groups on and
off again will tell you which group
your bulb is in.