Operation - Muller Light 404013 Mode D'emploi

ATTENTION!
Make sure there are no pipes or wires in the wall where you intend to drill.
1. Separate the two halves of the bracket. (fig. 1)
2. Use the rear of the bracket as a stencil to mark where you will drill.
3. Drill the holes and insert the wall plugs (if needed) in the holes. (fig. 2)
4. Screw the rear of the bracket onto the wall.
5. Place the upper part of the bracket on the screwed lower part. (fig. 3)
The bracket can now be used.
fig. 1 fig. 2 fig. 3

Operation

Once the bulbs are in place and the batteries are inserted into the tint remote
control, you can use the starter kit immediately by pressing the correct button
or calling up the function via the tint remote control.
Additional tint bulbs must first be integrated into the remote control
(see chapter „Adding a new bulb").
The tint remote control is a radio remote control.
tint-STARTER SET
INSTRUCTION MANUAL
59