Muller Light 404013 Mode D'emploi page 64

If you are using a tint white bulb that only emits white light, the
coloured light features will not be available. The bulb will be
switched off.
1. Unplug the lamp at the mains, remove the old bulb and screw the
new tint bulb into the socket.
2. Plug the lamp back in at the mains and set the corresponding light
switch to I or ON.
The new bulb will signal that it is in coupling mode by briefly increa-
sing and decreasing its brightness and changing colour if applicable.
If this does not occur, switch the bulb off and on again 5 times (see
„Resetting the tint bulb")
3. Press the group button repeatedly until all the LEDs above the group
button light up.
4. Hold the tint remote control very close (< 5 cm) to the new bulb.
5. Hold down the group button until the bulb begins to blink.
The feedback display will first blink red evenly; then, it will begin to
blink more quickly.
This means that the tint remote control has found a signal.
Continue to hold down the group button until the new light flashes 3
times to indicate that it has been connected to the tint remote control.
Keep holding down the group button until the bulb blinks again one
time, which shows that it has been assigned to default group (=group 1).
tint-STARTER SET
INSTRUCTION MANUAL
64