Muller Light 404013 Mode D'emploi page 54

DANGER of electric shock
• Before use, make sure that the existing power voltage matches the
required operating voltage of the item (see „Technical data")
• When inserting the batteries, pay attention to the right polarity.
• Do not use different types and do not use a used battery and a new
battery with each other.
• Do not use the item if it is damaged.
• Avoid contact of the item with water or other liquids.
• The bulbs can be adjusted via the included tint control or other control
units on a Zigbee basis. A conventional dimmer must not be used.
DANGER of Brand/combustion and/or explosion
• Risk of explosion if the battery is improperly replaced. Replace the
batteries only with the same or equivalent type of battery. Note the
„Technical data."
• Batteries must not be charged, reactivated, taken apart, thrown into
the fire or short-circuited. Otherwise, there is an increased risk of
explosion and phase-out, and gases can also escape!
• Avoid contact of battery fluid with skin, eyes and mucous membranes.
• In case of eye contact, rinse the affected areas immediately with plenty
of clear water and see a doctor immediately.
• When inserting the batteries, pay attention to the right polarity
• Always replace all batteries at the same time.
tint-STARTER SET
INSTRUCTION MANUAL
54