Using The Subwoofer (Sw-P330) - Yamaha Advanced YST NS-P330 Mode D'emploi

Placing the Speakers

Using the subwoofer (SW-P330)

VOLUME
INPUT
POWER
ON
OFF
1 Power indicator
Lights up GREEN when the POWER switch (4) is
turned ON; turns off when the POWER switch is
turned OFF.
2 VOLUME control
Adjusts the volume level. Turn the control clockwise to
increase the volume, and counterclockwise to decrease
the volume.
3 INPUT terminal
Input terminal for line level signals from the amplifier.
4 POWER switch
Press this switch to the ON position to turn on the
power to the subwoofer. When the power of the sub-
woofer is on, the power indicator (1) on the rear panel
lights up green. Press this switch again to set it to the
OFF position to turn off the power of the subwoofer.
8
Rear panel
VOLUME INPUT
POWER
ON
OFF
Pre-adjusting the subwoofer volume
Before you use the subwoofer, first adjust the vol-
ume balance between the subwoofer and the front
speakers by following the procedure below.
1
Set the VOLUME control to minimum (0).
2
Turn on the power to all other components.
3
Press the POWER switch to the ON position.
The power indicator on the rear panel lights up green.
4
Play a source that contains low-frequency
sounds. Adjust the amplifier's volume
control to the desired listening level.
5
Increase the volume gradually to adjust the
volume balance between the subwoofer and
the front speakers. In most cases, set the
control to a level at which you hear slightly
more bass than when the subwoofer is not
used.
6
Adjust the volume of the entire sound system
using the amplifier's volume control.
• If you replace the front speakers (NX-P200) with
other speakers, you must again balance the subwoofer
and surround speaker volume.
• For more information on adjusting the VOLUME
control, refer to "Frequency characteristics" on
page 11.