TEFAL CW100810 Mode D'emploi page 20

cafetie?re Direct serve CW 100 TEFAL.qxd:Cafet Tefal Express 01_FR. qxd
Problems, probable causes and corrective actions
Problems
The coffee does not flow.
The coffee is too short and the operation
is noisy.
Coffee leaks from the percolator head.
The pod is damaged when the appliance is
opened.
The preparation is pale and there is no
froth.
The button flashes rapidly and does not
stop.
The head cannot be closed correctly.
The head cannot be opened.
Probable causes
- The water tank is empty.
- Pump drained.
- Appliance scaled.
- Pod holder grid blocked.
- The water tank is empty.
- The water tank is not inserted
correctly into its housing.
- The head is dirty or impurities are
preventing it from closing correctly.
- The percolator head seal is damaged.
- There is still pressure in the head when it
is opened.
- The pod is not positioned correctly in the
pod holder.
- The pod holder is blocked.
- The pod is not compatible with the
coffee maker.
- The coffee maker has switched to a
safety mode because of overheating.
- The pod is not placed correctly in the
pod holder.
- The pod is not compatible with the
coffee maker.
- The appliance has switched to a
safety mode because of excess pressure.
- The pod is not compatible with the
coffee maker.
22
20/03/09
Corrective actions
- Fill the water tank.
- Fill the water tank, remove the filter
holder, lock the head and press the
button until the water flows.
- Descale the appliance.(see
descaling paragraph).
- Clean the pod holder with plenty
of water and blow into the tube.
- Fill the water tank.
- Push the water tank in correctly so
that it slots into the base.
- Clean the percolator head and the pod
holder with a soft cloth.
- Contact an approved service centre.
- Wait until the button stops flashing
before opening the head.
- Place the pod in a flat position in
the pod holder, ensure that the coffee is
evenly distributed in the sachet.
- Clean the pod holder with plenty
of water and blow into the tube.
- Change the pod.
- Leave the appliance to cool for 6 hours.
If the problem persists, contact an
approved service centre.
- Place the pod in a flat position in
the pod holder, and ensure that
the coffee is distributed evenly in
the sachet.
- Change the pod.
- Do not force the locking knob. Wait
for quarter of an hour. If the problem
persists, contact an approved service
centre.
- Only use flexible pods with a
diameter of 71 mm. ESE type pods
are not compatible with the coffee
maker.
11:54 Page