Publicité
Les langues disponibles
Les langues disponibles
INSTALL HOPPER GUARD AND LID
1. Install guard and lid as shown in Fig. 6. The tab on the
hopper should be inserted into the slot on the guard. Use
screws to secure hopper guard and lid to the hopper.
HOPPER LID (1)
M4 X 10 SCREW (2)
HOPPER GUARD (1)
FIG. 6
M4 X 10 SCREW (2)
HOPPER GUARD (1)
INSTALL SHELF BRACKET
1. Install the bracket as shown in Fig 7.
2. Tighten all hardware.
INSTALL SHELF
(Optional-Do not install if installing sear box)
1. Install shelf as shown in Fig 8.
2. Tighten all hardware
GREASE BUCKET
1. Hang grease bucket from tube as shown in Fig 9.
ASH CUP
1. Install Ash Cup as shown in Fig 9. Never use grill without
Ash Cup in place.
ASH CUP
DRIP TRAY
HOPPER LID (1)
HEAT DEFLECTOR
UPPER GRATE BKT (2)
PG24SG-11
M6 X 15 SCREW (4)
M6 FLANGE NUT (4)
M6 X 15 SCREW
GREASE BUCKET
GREASE BUCKET
FIG. 9
INSTALL DRIP TRAY
1. Install the Drip Tray as shown in Fig 10 and Fig11.
WARMING RACK AND COOKING GRATE
1. Install the cooking grate as shown in Fig 12.
FIG. 7
CLEAN-OUT KNOB ASSEMBLY INSTALLATION
Hand tighten the burner clean-out knob as shown in Fig 13.
FIG. 8
CLEAN-OUT PORT KNOB
1. Clean-out Port knob must be pushed in when grill is on.
Make sure pullout lock is pushed down and locks the
knob to prevent inadvertent opening of the clean-out port.
See Fig 14.
2. Lift pullout lock and pull clean-out port knob to empty
ash into ash cup. See Fig 15
3. See instructions for burner clean-out.
DRIP TRAY
HEAT DEFLECTOR
FIG. 10
HEAT DEFLECTOR
FIG. 11
UPPER GRATE (2)
PG24SG-5
LOWER GRATE (2)
PG24-70
FIG. 12
PG24-9 (1)
BURNER PULLOUT KNOB
FIG. 13
DRIP TRAY
Publicité
