Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Remove all loose parts from the inside of the grill and
hopper. Lay a blanket or piece of cardboard down to protect
the grill.
ATTACH THE LEGS
With the help of another person flip the grill upside down
on the blanket or cardboard. The grill lid and hopper lid will
swing open when doing this so be careful not to damage
the lids. The grill may also want to roll on its lid so one
person should hold the grill steady while the other person
assembles the bottom legs and wheels.
1. Lay the grill on its back.
2. Install each of the 4 legs as shown in Fig 1. Make sure
the legs with wheels are attached to the right side of
the grill with the wheels facing out. Note: Front legs are
marked with an F and back legs are marked with a B.
3. Stand the grill upright
4. Tighten all hardware.
ATTACH BOTTOM SHELF
1. Install bottom shelf as shown in Fig. 2 by installing
hardware in each of the 4 corners.
2. Tighten hardware.
FIG. 2
M8 FLANGE NUT
ATTACH CHIMNEY AND CHIMNEY CAP
1. Install chimney to grill as shown in Fig 3. Make sure to
install the gasket between the grill and the chimney.
2. Tighten all hardware.
3. Install M6 x 76 Bolt through chimney cap and secure
M8 FLANGE NUT
M8 X 20 BOLT
M8 LOCK WASHER
FIG. 1
M8 X 60 BOLT
M6 X 76 BOLT
M6 NUT
using Qty (1) M6 nut. Thread second nut onto bolt leaving
M8 X 60 BOLT
approximately 1.5" to the top of the cap. Thread cap
assembly down into the chimney bracket until the lower
nut hits the bracket. See Fig 3.
M6 X 76 BOLT
M6 NUT
M6 X 15 SCREW
CHIMNEY GASKET
4. The height of the chimney cap can be adjusted for
summer and winter. In the summer the gap should be
approximately 1-1/2". In the winter the gap should be
approximately ½".
5. Tighten all hardware.
INSTALL HANDLE
1. Install the handle as shown in Fig 4.
2. Tighten all hardware.
FIG. 4
HANDLE
HANDLE DEFLECTOR
M6 HANDLE SCREW (2)
INSTALL HOPPER HANDLE
1. Install hopper handle as shown in Fig. 5.
FIG. 5
ASH CUP
FIG. 3
HANDLE BEZEL (2)
Publicité
