Bras ATLAS L Carnet D'instructions page 16

EN GLIS H
A T L A S L
3
Slide the outer spiral out (see figure 10) and then the inside
auger (see figure 11).
4
Remove the bowl gasket from its seat (see figure 12).
5
Remove the faucet assembly sliding the pin and pulling up
figure 9
figure 10
figure 11
figure 12
the handle. (see figure 13).
6
Slide the drip tray out and empty it.
5. 3. 2 CLEANING
IMPORTANT
Do not attempt to wash any machine components in a
dishwasher.
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source.
1
Prepare at least two gallons of a mild cleaning solution of
warm (45-60 °C 120-140 °F) potable water and dishwashing
detergent. Do not use abrasive detergent.
Important: if present, follow label directions, as too strong a
solution can cause parts damage, while too mild a solution will
not provide adequate cleaning.
IMPORTANT
In order to prevent any damages to the dispenser use
only a detergent suitable with plastic parts.
2
Using a brush, suitable for the purpose, thoroughly clean all
disassembled parts in the cleaning solution.
ATTENTION
When cleaning the machine, dump it, do not allow exces-
sive amounts of water around the electrically operated
components of the unit. Electrical shock or damage to
the machine may result.
3
Do not immerse the lighted top covers in liquid. Wash them
16
figure 13