Bras ATLAS L Carnet D'instructions page 13

not overfill.
The exact quantity of product (expressed as liters and gallons)
is shown by marks on the bowl.
3
In case of products to be diluted with water, potable water,
pour water into bowl first, then add correct quantity of product.
In case of natural squashes, it is advisable to strain them, in
order to prevent pulps from obstructing the faucet outlet.
4
To obtain the best performance and result, use bases
designed to be run in Granita freezers. Such bases have a
sugar content of 34 degrees Baumé corresponding to 64
degrees Brix.
For soft drinks the bases are to be diluted with more water, on a
1 plus 5/5.5 basis.
In any case follow the syrup manufacturer's instructions for
both Granita and soft drink recipes.
If natural juices (e.g. lemon, orange) as well as sugarless
products (e.g. coffee) are used, dissolve 150 - 200 grams of
sugar per liter.
IMPORTANT
However Granita mix may be done, its Brix (sugar per-
cent content) must be at least 13.
IMPORTANT
Operate the dispenser with food products only.
IMPORTANT
This appliance is not intended for use by person (inclu-
ding children) with reduced physical sensory or mental
capabilities, or lack of experience and knowledge unless
they have been given supervision or instruction concer-
ning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not
play with the appliance.
5
Install the covers and check that they are correctly placed
over the bowls. There must be a correct electrical connection
between the bowl and the cover.
6
Set the control switches
5.1 DESCRIPTION OF CONTROLS.
7
Always leave the dispenser on, as the refrigeration stops
automatically when Granita reaches the proper thickness. The
mixers will continue to turn.
8
To remove the cover push any of the two fixing buttons and
as shown in chapter
13
lift it. (see figure 1)
9
It is possible to lock the cover by rotating the two keys
located on its lower part. (see figure 2)
10
To release a locked top cover it is necessary to insert a
sharpened object in the hole located in the middle of the fixing
figure 1
figure 2