Kärcher PC 60/130 T Mode D'emploi page 6

 Connect the switch as shown in the circuit diagram.
 Connect the cable jumper between P1 and P2.
 Install the switch using the seal washer, the seal and the cyl-
inder screws.
 Insert the spring element into the handle as shown.
 Insert the O rings onto the handle as shown.
6
English
1.
2.
 Install operating panel. Caution! Do not clamp any cables.
 Insert the preinstalled handle.
 Remove the cover.
 Install the assembly kit - skimmer.
 Route and affix the cable to the skimmer motor.