Publicité
Les langues disponibles
Les langues disponibles
5.
Remove the protective cap and attach the gas supply hose to the device (left
screw threads!). Firmly screw on the nut with suitable tools for unproblematic
gas supply (Diagram 1).
6.
Connect the pressure regulator to
the gas bottle. Firmly screw the nut
on so that no gas leakage can
occur. Make sure when you install
the gas bottle that the gas hose is
not bent or kinked. Avoid turned
and pulled tension.
7.
Check that the device is correctly
attached to the gas bottle and
perform a complete gas leakage
test (see the description below in
this booklet).
8.
When you're sure everything is in
order, open the gas tap. (Diagram 2).
9.
Turn the regulator button to the
maximum position.
10. Now insert the plug into the socket.
Then set the power switch to I (on)
(Diagram 3). The ventilator will
start running.
11. Wait until the ventilator is running steadily and stable. Now press the right-
hand button of the gas valve and keep it pressed down for 10 seconds. Then
with your left hand simultaneously
press the ignition button a few
times to ignite the device (Diagram
4).
12. After the gas starts burning, keep
the gas valve pressed in for
another 15 seconds. After that, you
can let go and the gas will burn
continuously (Diagram 5).
13. Now turn the regulator button until
it reaches the desired flame length,
in accordance with your desired
heat output.
14. To switch off the device, close the gas tap of the gas bottle and wait until the
flame goes out. Now switch the power switch to O (off) and remove the plug
from the socket. Finally, disconnect the gas supply hose from the gas bottle.
Attention! The device will remain hot for a while after use. Always remove the
plug from the socket when the unit is not in use.
15. If you have to change the gas bottle or want to use the device after a period of
storage, you must repeat the entire process, including the gas leakage test.
24
Publicité
