Publicité
Les langues disponibles
Les langues disponibles
Operation
A. How do I safely connect a (new) gas bottle to my Eurom patio heater?
Uncouple the old gas bottle
1. Switch off the patio heater with the control knob and close the gas tap on top of
the gas bottle by hand. Even with an empty gas bottle. (Note: turn closed = turn
clockwise)
2. Let the patio heater cool down for at least 15 minutes. After 15 minutes, check
that there are no glowing parts anywhere.
3. Disconnect the pressure regulator from the old gas bottle by hand, (preferably)
do not use any tools. (Note: unscrew = turn clockwise)
Couple a new gas bottle
1. Keep all possible ignition sources away. Think e.g. open flames, sparks,
cigarettes, hot surfaces, electrical equipment, etc.
2. Take measures to prevent the creation of electrostatic charges.
3. Avoid sparks from iron on iron.
4. Check whether the black sealing rubber is present in the union nut of the
pressure regulator and is in good condition.
5. Connect the pressure regulator to the gas bottle. Tighten the union nut firmly by
hand, sufficient to obtain a gas-tight connection. (Note: tighten = turn
counterclockwise).
6. Open the gas tap on top of the gas bottle. (Note: turn open = turn
counterclockwise).
7. When you hear a hiss, immediately close the gas tap on top of the gas bottle.
The connection is then not closed. Tighten the union nut of the pressure
regulator.
8. Do a leak test with soap water. When soap bubbles form, the connection is not
closed. Immediately close the gas tap on top of the gas bottle. Tighten the union
nut of the pressure regulator.
9. If no leakage has been detected, you can ignite the patio heater.
B. Operation general
1.
Check the heater for damage or defects. Do not use a damaged heater, but
contact your supplier.
2.
Make sure to use undamaged, full gas bottles with propane or butane, suitable
for use.
3.
Select a place for the heater that meets all the safety instructions and place it
on a level, stable, horizontal surface with non-flammable material. Do not plug
it in and the set the power switch to O (off).
4.
Firmly attach the gas hose with suitable tools to the pressure regulator (left
screw threads!)
23
Publicité
