Bosch GBM9-16 Consignes De Fonctionnement/Sécurité page 4

1619PA9714.qxp_GBM9-16 11/19/15 12:55 PM Page 4
Position yourself to avoid being caught
between the tool or side handle and walls
or posts. Should the bit become bound or
jammed in the work, the reaction torque of
the tool could crush your hand or leg.
If the bit becomes bound in the
workpiece, release
immediately, reverse the direction of
rotation and slowly squeeze the trigger to
back out the bit. Be ready for a strong
reaction torque. The drill body will tend to
twist in the opposite direction as the drill bit is
rotating.
Do not grasp the tool or place your hands
too close to the spinning chuck or drill
bit. Your hand may be lacerated.
When installing a drill bit, insert the shank
of the bit well within the jaws of the
chuck. If the bit is not inserted deep
enough, the grip of the jaws over the bit is
reduced and the loss of control is increased.
Do not use dull or damaged bits and
accessories. Dull or damaged bits have a
greater tendency to bind in the workpiece.
Do not mix food. Power tools and their
accessories are not designed for processing
food.
The mixing container must be suitable for
mixing and must stand securely. A
container that is not properly secured may
move uncontrolled.
Follow the instructions and warnings in the
Material Safety Data Sheets (MSDS) of the
material to be mixed. Material to be mixed
may be harmful.
When removing the bit from the tool avoid
contact with skin and use proper
protective gloves when grasping the bit or
accessory. Accessories may be hot after
prolonged use.
Check to see that keys and adjusting
the trigger wrenches are removed from the drill
before switching the tool "ON". Keys or
wrenches can fly away at high velocity
striking you or a bystander.
Do not run the drill while carrying it at
your side. A spinning drill bit could become
entangled with clothing and injury may result.
This tool may be used with sanding and
polishing disks, grinding wheels, wire
wheel and wire cup brushes. These
accessories must be rated for at least the
speed recommended on the tool warning
label.
running over rated speed can fly apart and
cause injury.
Avoid bouncing and snagging the wheels,
discs or brushes especially when working
corners, sharp edges, etc. This can cause
loss of control and kickback.
Safety Rules for Mixers
Do not use this tool for mixing corrosive
(acids), explosive or combustible materials.
The machine is intended for mixing pulverized
building materials such as mortar, plaster,
adhesives, as well as solvent free paint,
varnish and similar substances.
-4-
Wheels and other accessories