Bosch GBM9-16 Consignes De Fonctionnement/Sécurité page 10

1619PA9714.qxp_GBM9-16 11/19/15 12:55 PM Page 10
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed trigger
switch. The tool can be turned ON or OFF by
squeezing or releasing the trigger. The speed
can be adjusted from the minimum to maximum
REVERSING SWITCH BUTTON
The reversing switch button is located above
the trigger switch and is used to reverse
rotation of the bit. For forward rotation, (with the
chuck pointed away from you and the power
cord side positioned down) move button to the
far left. For reverse rotation move the button to
the far right (Fig. 4).
to a complete stop. Shifting during rotation of
the chuck can cause damage to the tool.
Your tool is equipped with chuck key that can
CHUCK KEY AND KEY HOLDER
be conveniently located on the cord protector
where it is always handy and unlikely to get lost
or misplaced (Fig. 1).
Operating Instructions
Do not change direction of
rotation until the tool comes
nameplate RPM by the movement of the trigger
towards the handle, controlled by the pressure
applied to the trigger. Apply more pressure to
increase the speed and release pressure to
decrease speed (Fig. 1).
-10-
FIG. 4