Electrolux EDC2086PDW Notice D'utilisation page 4

Masquer les pouces Voir aussi pour EDC2086PDW:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4
www.electrolux.com
the accessory. Read it carefully before installation
(Refer to the Installation leaflet).
The appliance can be installed as freestanding or
below the kitchen counter with correct space (Refer to
the Installation leaflet).
Do not install the appliance behind a lockable door, a
sliding door or a door with a hinge on the opposite
side, where the appliance door can not be fully
opened.
The ventilation openings in the base (if applicable)
must not be obstructed by a carpet.
Connect the mains plug to the mains socket only at
the end of the installation. Make sure that there is
access to the mains plug after the installation.
Ensure you have good ventilation in the installation
room to avoid the back flow of gases into the room
from appliances burning other fuels, including open
fires.
Exhaust air must not be discharged into a flue which is
used for exhausting fumes from appliances burning
gas or other fuels. (if applicable)
If the supply cord is damaged, it must be replaced by
the manufacturer, its Authorised Service Centre or
similarly qualified persons in order to avoid a hazard.
Obey the maximum load volume of 8kg (refer to the
"Programme chart" chapter).
Do not use the appliance if industrial chemicals have
been used for cleaning.
Wipe away lint that has accumulated around the
appliance.
Do not run the appliance without a filter. Clean the lint
filter before or after each use.
Do not dry unwashed items in the tumble dryer.
Items that have been soiled with substances such as
cooking oil, acetone, alcohol, petrol, kerosene, spot
removers, turpentine, waxes and wax removers

Publicité

Chapitres

Table des Matières
loading

Table des Matières