Publicité
Les langues disponibles
Les langues disponibles
Foodservice Plumbing Products Installation Instructions
WARNING
!
Read this Manual BEFORE using this equipment.
Failure to read and follow all safety and use information can result in death,
serious personal injury, property damage, or damage to the equipment.
Keep this Manual for future reference.
GENERAL INSTRUCTIONS:
Most faucets are supplied with mounting hardware, including ½" nipples. For installation
instructions, we will assume that hot and cold water supplies end in ½" nipples. We
recommend using a 1
1
/
" hole in the deck or backsplash to accommodate the ½"
4
supply nipples. For added convenience it is suggested that Hydro-Force Mounting Kit
(LFFRMK-W) be utilized with the LLP-WS8B-AF12 Series fixtures. Refer to instructions.
1. Turn off water supply at main source.
2. Hand-tighten all parts prior to tightening with wrench.
3. Do not force parts together.
4. All plated surfaces should be handled with care; avoid scratching with tools.
5. Use Teflon tape or pipe joint compound when making threaded connections
to water supply lines.
DECK MOUNT
FAUCET
TIGHTEN
BODY
COUPLING NUT
TIGHTEN FLANGE
AGAINST DECK
1
/
" WATER
2
SUPPLY LINE/
NIPPLE
MOUNTING KIT INCLUDES:
Rubber Washer, Steel Washers,
Flange, Nipple and Locknut
AVAILABLE PARTS INCLUDE:
REPLACEMENT CARTRIDGE
HOT VALVE ASSEMBLY
MODEL LFFRRV-H
™
ASSEMBLE COUPLING TO SINK DECK
Apply Teflon tape or pipe joint compound to the supply line nipples. Place
nipple through holes in deck. Assemble flange of each coupling to one
nipple, then the other. Thread flange loosely against wall or backsplash.
ASSEMBLE FAUCET TO COUPLINGS
Carefully orient, mount and hand-tighten the faucet to the two couplings.
Be sure to include the washers provided. Use wrench to tighten flange
against wall or backsplash. Maintain alignment of faucet to sink while
tightening. Now wrench-tighten couplings to faucet body, then tighten
flange against sink/backsplash.
WALL MOUNT
SINK/BACKSPLASH
WASHER
1
/
" WATER SUPPLY
FAUCET
2
LINE/90˚ NIPPLE
BODY
MTG. KIT*
1
TIGHTEN
COUPLING
FLANGE
2
TIGHTEN FLANGE
NUT
AGAINST SINK/
BACKSPLASH
*SHOWN WITH OPTIONAL 90˚
MOUNTING KIT NO. LFFRMK-W
REPLACEMENT CARTRIDGE
COLD VALVE ASSEMBLY
MODEL LFFRRV-C
DOUBLE PANTRY
FAUCET BODY
TIGHTEN LOCKNUT
WASHER
AGAINST DECK
LOCKNUT
YOKE
3
/
"
/
" WATER SUPPLY
8
1
2
TAILPIECE
LINE/NIPPLE
PRE-RINSE BUTTON
VALVE ASSEMBLY
MODEL LFPRSH-BV
Hydro-Force is available exclusively from:
Dormont Manufacturing
Export, PA 15632
Tel: (800) 367-6668
foodservice.watts.com
SINGLE PANTRY
FAUCET
BODY
WASHER
SINK/BACKSPLASH
FLANGE
/
" WATER SUPPLY
1
2
LINE/NIPPLE
TIGHTEN
FLANGE AGAINST
SINK/BACKSPLASH
PRE-RINSE REPLACEMENT HOSE WITH GRIP
MODEL LFPRH-GXX
For additional information on replacement parts
please visit our website: foodservice.watts.com
Publicité
