Kobalt 0332041 Mode D'emploi page 8

CARE AND MAINTENANCE
WARNING: To avoid personal injury, always shut off and unplug the unit and relieve
all air pressure from the system before performing any service on the air compressor.
Regular maintenance will ensure trouble-free operation. The items listed here
should be inspected on a regular basis.
• On a daily basis, drain the tank to prevent corrosion from forming inside
the tank. Drain the condensation at the end of every day. Wear protective
goggles. Relieve the air pressure in the system and then open the drain
valve (G) on the bottom of the tank.
• On a daily basis, pull the pressure relief valve (H) to ensure that it is
operating properly and to clear the valve of any possible obstructions.
• Check all connections to ensure they are tight. A small leak from any part of the
compressor will reduce the unit's performance. Spray a small amount of soapy water
around the area of the suspected leak with a spray bubble. If bubbles appear,
repair or replace the faulty component. Do not overtighten any connections.
• Before storing the unit for a long period, do the following:
• Use an air blow gun (not included) to clean all dust and debris from the compressor.
• Disconnect and coil the power cord.
• Pull the pressure relief valve to release all pressure from the tank.
• Drain all moisture from the tank.
• Cover the entire unit to protect it from moisture and dust.
kobalttools.com
8
I