Kerbl SuperHeat Analog 14000 Mode D'emploi page 12

5. Functional principle
The SuperHeat Digital device uses the heat flow in the milk: the heated milk rises to the surface, and the cold milk
drops to the bottom of the bucket where it is then heated up again by the radiator.
6. Operation
6.1 Before first use
Before first use, thoroughly clean the surface of the radiator (4) with lukewarm water. Inspect the device for visible
defects. In particular, you should check the connection cable (2), the housing cover bolts, that the display film is
intact as well as the connection of the immersion tube (3) to the radiator (4).
6.2 Before switching on
Before connecting the plug to the socket, place the device in the liquid to be warmed.
Note the maximum and minimum immersion depth of the device. The maximum immersion depth is marked on the
immersion tube (3). The minimum immersion depth is determined by the transition of the immersion tube (3) to the
radiator (4). Ensure that the bucket or the container with the liquid to be heated stands securely on level and stable
ground, so as to prevent the device from falling over.
6.3 Switching on the device and heating the liquid
Insert the connection cable (2) plug into the socket.
Set the desired temperature on the thermostat (6).
The red check light (7) indicates whether the heating element is currently heating.
- check light on: the heating element in the radiator (4) is heating
- check light off: the heating element in the radiator (4) is not heating
After the target temperature has been reached, the heater switches off, the check light extinguishes.
Tip: Wait for the heating process to complete, then mix the liquid by moving
the radiator up and down a few times to achieve even temperature distribution. If the SuperHeat device continues to
be left in the container, the liquid will be re-heated again when the temperature drops so as to
ensure that the pre-set target temperature is maintained (heat retention mode).
6.4 Switching the device off
Turn the thermostat to "0" to shut off the device. To switch off the device, remove the connection cable from the socket.
CAUTION!
Risk of physical injury and material damage if used incorrectly.
The surface of the radiator will still be hot when the device is switched off.
Do not touch the radiator or place it on heat-sensitive surfaces.
Tip: The device should be placed in cold or warm water immediately after use. This facilitates cleaning of
the radiator and allows it to cool down evenly.
12
~ 40° C
~ 90° C
0