Ecoflam KITMD-RWF50 Notice D'emploi page 8

EN
RWF 50/55
- Microprocessor regulator - Display
Display diSP
By configuring the position of the decimal point and automatic changeover (timer), both LED indications can be adapted to the respec-
tive requirements. Timeout tout for operation and the locking of levels can be configured as well.
SETTING THE DISPLAY
To adjust display proceed as follows :
- Press the Enter button to access the user level
Enter
so that the first parameter of the configuration level is displayed. - Press the t button so that diSP is appears. - Press the
in display flashes diSP. - Change the value using the keys tand s ,press
Parameter
Upper display
diSU
Upper display
Lower display
diSL
Lower display
Timeout
tout
Decimal point
dECP
Decimal point
Locking of levels
CodE
8 www.ecoflam-burners.com
OPr, press the t botton, appare nel display di base
OPr
Value/ Selection Description
Display value for upper display
0 Switched off
1 Analog input InP1
4 Controller's angular positioning
6 Setpoint
7 End value with thermal shock protection
Display value for lower display
0 Switched off
1 Analog input InP1
4 Controller's angular positioning
6 Setpoint
7 End value with thermal shock protection
0...
Time (s) on completion of which the controller returns automatically to
180...
the basic display, if no button is pressed.
255
0 No decimal place
1 One decimal place
2 Two decimal places
If the value to be displayed cannot be shown with the programmed
decimal point, the number of decimal places is automatically reduced. If
the measured value drops again, the number of decimal places is
increased until the programmed value is reached
0 No locking
1 Locking of configuration level
2 Locking of parameter level
3 Locking of keyboard
ConF. - Press the
ConF
Enter to confirm.
Enter
Enter button
Enter
Enter button Enter
420010571400