Orbegozo SF 0246 Manuel D'instructions page 11

SF 0246
2. Loosen the height adjustment nut (13) and pull up extensible tube (12) until desire height, tighten the nut
to set desire height.
3. Place the fan's body (8) in the extensible tube and tighten the fixing screw (10) to be fit in that position.
For table fan
1. Place inner base and outer base (15 y 16) on a table, screw the base support (17) in the base.
2. Place the fan's body (8) on the support (17) and tighten the screw (10).
For wall fan
1. Place the wall hook (22) on desire position, mark with a pen the holes for screws and make a drill. Place
the stopper in the Wall and screw the hook with the screws.
2. Place fan's body (8) in the wall support (19) and fit it with the screw (10). Fit the wall support on wall
hook.
ASSEMBLY OF BLADE AND GRILLS
1. Remove plastic sleeve of motor, grills and blade. Place rear grill (6) on the motor frontal through motor
shaft (7). Ensure the handle at the rear grill is facing up and that all guiding pegs on the motor housing are
lined up with cutouts on the rear grills.
2. Secure the rear grill into the place with the plastic nut (5). Fasten the plastic nut firmly onto the motor
housing by tightening it in a clockwise direction.
3. Install the fan blade (4) onto motor shaft (7) with the cutouts fitted. Place blade's nut (3) on the motor
shaft after the blade. Fasten it by tightening in a counter clockwise direction.
4. Fit front grill (1) with front grill ring (2ª) against rear grill ring (2b) by aligning the alignment mark on the
top of the grill ring, closing them together by the hooks on front grill ring and slots on the rear grill ring,
twisting the front grill clockwise to the lock position, the snapping lock pin (20) should pop in. Tighten the
lock screw (21) to secure the snapping lock pin.
OPERATING INSTRUCTIONS
Using the control panel and remote control
This fan is equipped with 3 speeds, 3 fan modes, timer and remote control. For your
convenience, the buttons on control panel and remote control are the same.
- Timer. Each time you press this button, the timer increase 30 minutes from
minimum 30 minutes to maximum 7.5 hours. After the time runs out, the fan will
automatically shut off. Control panel shows 4 lights (0.5h, 1h, 2h, 4h) some of them will
light and the time of timer will be their sum. Examples: 0.5h lights, 30 min of timer. 0.5h
and 2h light, 2h and 30 min of timer.
- Mode. Each time you press this button will set a mode. Normal, there is no light on
11