AUTO-HAK F08 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
M10x30
C
A
M12x35
14
5
B
M12x35
This towbar is designed to assembly in following cars:
PEUGEOT 406 D8, D9 ESTATE, produced since 1996 till 02.1999 and
since 03.1999 till 2004, catalogue no. F08 and is prepared to tow trailers
max total weight 1700 kg and max vertical load 80 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
14
A
M10x30
C
M12x35
1
17
16
18
16
M8x30
3
From manufacturer
1. Find holes in the chassis on the left and right side then put the
special caged nuts M10 (pos. 14) from the towbar accessories
2. Fix the side supports (pos. 4 and 5) through holes (pos. A)
A
with bolts M10x35mm (pos. 8).
14
3. Position the bar of towbar (pos. 1) between the supports and
then fix with M12x35mm bolts (pos. 7) through holes (pos. B
M12x35 and C).
4. Fix the socket plate (pos. 3) as shown on the drawing.
5. Tighten all nuts and bolts according to the torque shown in the
table.
B
6. Position the ball of towbar (pos. 2) and fix with M12x70mm
bolts (pos. 6) from accessories.
M12x70
7. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station).
8. Complete the paint cover of towbar (during the mounting
paint cover could be destroyed).
2
After install the towbar you should get adequate note in registration
book (at authorised service station).The car should be equipped with:
• Indicators
• Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of
towbar must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 25 Nm M 10 55 Nm
M 12 85 Nm M 14 135Nm
NOTE