AUTO-HAK F01 Instructions De Montage

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
5
C
4
9
D
8
6
5
M10x30mm
This towing hitch is designed to assembly in following cars:
PEUGEOT 106, 3/5 doors, produced since 05.1996 till 2003, catalogue no.
F01 and is prepared to tow trailers max total weight 1100 kg and max
vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
B
M10x30mm
M10x30mm
E
8
1
F
G
3
From manufacturer
1. Take out the spare wheel.
2. Put caget nuts M10 (pos. 5) into existing holes in chassis members
(pos. A and B) and in the bracket (pos. C).
3. Put the caget nut M8 (pos. 6) into the existing hole in the left chassis
member (pos. D).
5
4. Apply the left bracket (pos. 4) and fix loosely through holes (pos. A
and C) using bolts M10x30mm (pos. 8) and through the hole (pos.
D) using bolt M8x30mm (pos. 9) from the towing hitch equipment.
H
5. Apply the main bar of the towing hitch (pos. 1) from the bottom and
fix through holes (pos. B, E, F and G) using bolts M10x30mm (pos.
8) and through hole (pos. H) to the original towing eye of the car
9 using bolt M8x30mm (pos. 9).
6. To installed towing hitch fix tow-ball (pos. 2) and socket plate (pos.
3) using bolts M12x75mm (pos. 4) from the towing hitch
M12x75mm
accessories.
7. Tighten all bolts according to the torque shown in the table.
8. Connect electric wires of 7-poles socket according to the instruction
of the car. (Recommend to make at authorized service station).
9. Complete paint layer damaged during installation.
2
M6 - 11 Nm
M 12 - 87 Nm
After install the towing hitch you should get adequate note in registration
book (at authorised service station).The car should be equipped with:
• Indicators
• Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must be
always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 14 - 138 Nm
NOTE
M 10 - 50 Nm
M16 - 210 Nm