AUTO-HAK F 29A Instructions De Montage

FITTING INSTRUCTION
11
12
5
7
11
9 1
11
25
2
This towbar is designed to assembly in following car:
PEUGEOT 407 4 doors, produced since 2004, catalogue number F 29A
and is prepared to tow trailers max total weight 1600 kg and max vertical
load 65 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
Clamp mark
in acc. with
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
17
17
22
23
3
13
14
6
10
24
From manufacturer
1. Disassemble rear lights.
2. Disassemble bumper cover. Under cover is placed plastic reinforcement. On
the left side of this reinforcement unscrew 4 bolts M8. Put left fishplate (pos.
Cables joining
5) in this way, so 4 holes in the fishplate agree with holes in the reinforcement.
Fix loosely using bolts M8x50mm (pos. 13) from accessories, remember – put
2 bolts M12x40mm (pos. 11) before fix, see drawing.
3. Next make the same actions on the right side. Unscrew 4 original bolts M8.
Put right fishplate (pos. 4) in this way, so 4 holes in the fishplate agree with
holes in the reinforcement. Fix loosely using bolts M8x50mm (pos. 13),
remember – put 2 bolts M12x40mm (pos. 11) before fix, see drawing.
4. On protruding from fish-plates bolts M12 put side brackets pos. 8 and 9, next fix it by
bolts M12x40mm (pos. 11).
5. In chassis members find plugged holes (per one on each side), the outside.
Unlock them.
According to the drawing put side handles pos. 6 and 7 and fix it by bolts
6.
M10x40mm (pos. 12) to chassis members and next between mounted elements
12
put main bar of the towbar (pos. 1) and fix it to already mounted side elements
by bolts M12x40mm (pos. 11)
11
7. Tighten all bolts according to the torque shown in the table.
8. Fix body of the automat (pos. 24) using bolts M12x25mm (pos. 10) from
accessories. Place tow-ball (pos. 2) according to supplied instruction.
9. Fix the socket plate (pos. 3) as shown on the drawing.
10. Reinstall the bumper after remove element show on figure 2.
4
11. Connect electric wires of 7-poles socket according to the instruction of the car.
8
11 (Recommend to make at authorized service station)
12. Complete paint layer damaged during installation.
Fig. 2
Fitting instructions
.
Remove