Publicité
Les langues disponibles
Les langues disponibles
6.
Lead the L-marked end of the wire assembly to the left running lights.
Clamp the supplied quick connectors on the following vehicle wires:
Colour of the wire Function
grey/purple
blue/green
Connect the terminal of the blue/green wire from the wire assembly to the quick connector on the grey/purple
vehicle wire.
Connect the terminal of the grey/blue wire from the wire assembly to the quick connector on the blue/green
vehicle wire.
7.
Lead the R-marked end of the wire assembly to the right running lights.
Clamp the supplied quick connectors on the following vehicle wires:
Colour of the wire Function
grey/yellow
blue/brown
black/blue
blue/yellow
Connect the terminal of the purple/white wire from the wire assembly to the quick connector on the grey/yellow
vehicle wire.
Connect the terminal of the grey/white wire from the wire assembly to the quick connector on the blue/brown
vehicle wire.
Connect the terminal of the purple/black wire from the wire assembly to the quick connector on the black/blue
vehicle wire.
Connect the terminal of the blue/red wire from the wire assembly to the quick connector on the blue/yellow vehicle
wire.
Connect the brown and brown and white/brown wires to the ground point (install on the ground point or use a
metal sheet screw).
Trailer module installation
8.
Install the trailer module above the left running lights on the left side of the boot by means of an adhesive tape.
Connect 15-pin plug to the module.
9.
Lead the red/blue, red/blue (double) and blue wires along the vehicle wire assembly, near the wheel compartment
and the sill panel, to the A pillar.
10.
Lead the red/blue feeder cable (double) through the prepared cable bush and fasten in fuse bases. Connect the
red/blue feeder cable (double) at the end to the fuse base and 20A fuse. Ensure that 12V power is supplied (Fig. 5)
Connection of Datenbus signal cable (blue).
11.
Uncover the A pillar cover near the floor and the sill cover on the passenger side.
Lead the blue wire from the compartment near the left A pillar along the dashboard edge to the module in the
compartment of the right A pillar.
The light module is located near the A pillar. Remove the front black plug from the light module and carefully pull
out the blue connector holder from the cover of the connection plug housing (Fig. 2).
Insert the blue wire terminal into the chamber No. 12; assembly the plug in the reverse order and connect to the
light module (Fig. 3-4).
Trailer indicator defect is signalled by a control light of the vehicle by increased flashing frequency!!
Fix all the leads with supplied band clips, assemble previously disassembled parts.
Connect accumulator and check all vehicle functions with connected trailer or other suitable testing device.
left indicator, L
left running lights, 58-L
right indicator, R
right running lights, 58-R
stop light, 54
reversing light, 54
Remarks regarding trailer indicator operation:
Publicité
