bosal 04 11 13 Instructions De Montage page 3

04 11 13 / 01.12
Packing list: 1 10-conductor cable set
1 13-pin socket
7 Quick connector
1 Trailer indicator modules
Disconnect the earth lead from the battery.
1.
Remove the rear plate cover, both side covers of the boot, the hat compartment and the rear light.
2.
To lead the wire assembly, bore a 40 mm hole in the vehicle below the left lights. Apply appropriate corrosion
3.
preventive on the hole edges (Picture 1).
Connect cable set in the following way:
4.
a) Draw 10-connector end of cable set with iwith metal terminal through the hole referred to in point three from
boot outside and then through the hole in socket base. Fasten cable bush located on cable bunch in the hole
inside the vehicle..
b) There are two different washers under the socket. One is used by side entrance of leads, the other - in axis
entrance.
Side entrance: used in permanent assembly of tow hook with closed socket holder and detached tow hook with
folded socket holder. In such event, remove overpass in casing of connection socket.
Note !!! Use washer under socket assigned to side entrance for folded socket holder. Remove the other washer
assigned for axis entrance (it will not be used).
Axis entrance: used in permanent assembly of tow hook with opened socket holder and detached tow hook
without folded socket holder.
Remove washer assigned for side entrance (it will not be used).
c) Socket is connected according to the following scheme:
13 pin
Contact description
Function
Indicator left
Trailer fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Reversing light
Trailer current supply
Charge line plus
Charge line earth
Not assigned
Earth (trailer)
Assemble connection socket with packing washer using enclosed screws and nuts on socket holder:
5.
a) Carefully fasten washer in the appropriate way,
b) Fasten electric bunch in such a way that there are no sharp bends and no wear.
Electrical Set for Trailer Connection
Part no. 04 11 13
13-pin
1 Nuts M6
3 Screws M5X35
3 Nuts M5
1 Screws M6X10
Installation instruction
Cable colour
1
black/white
2
grey
3
brown
4
black/green
5
grey/red
6
black/red
7
grey/black
8
blue/red
9
red/blue 2,5mm 2
10
11
12
13
white/brown 2,5mm
BMW Mini manufactured 06.01 -
1 Spring washer M6
3 Spring washer M5
2 Fuse base with a fuse
1 Red/blue connection cable 2 Adhesive tape
9
10
11
Contact description in
13-pin socket
2
1 Sheet-metal screw
16 Cable ties 140 mm
3 Cable ties 300 mm
8
7
1
6
2
4
3
5
12
13