Beninca BRAINY Mode D'emploi page 19

Some messages that are displayed in the event of malfunctions are shown hereunder:
Error, motor 1 encoder
Enc1
Error, motor 2 encoder
Enc2
Error, motor 1 obstacle
Amp1
Error, motor 2 obstacle
Amp2
Error, check motor 1 circuit
Err1
Error, check motor 2 circuit
Err2
Error, check actiation relay
Err3
Error, check PHOTA photocell
Err4
Error, check PHOTC photocell
Err5
Error, activated sensitive edge (during self-set)
Err6
Error, activated stop (during self-test)
Err7
Error, activated input (during self-test)
Err8
In the event of malfunctions, by pressing key + or - the status of all inputs (limit switches,
control and safety) can be displayed. One segment of the display is linked to each input.
In the event of failure it switches on according to the following scheme.
If the product must be dismantled, it must be disposed according to regulations in force regarding the differentiated waste disposal and
the recycling of components (metals, plastics, electric cables, etc..). For this operation it is advisable to call your installer or a specialised
company.
ERROR mESAGES
Check the connection to motor 1 encoder
Check the connection to motor 2 encoder
Check the presence of obstacles on the motor 1 leaf stroke
Check the presence of obstacles on the motor 2 leaf stroke
Check connections to motor 1
Check connections to motor 2
Ask for technical assistance
Check connections, alignment of PHOT A photocell or obstacle
present.
Check connections, alignment of PHOT C photocell or obstacle
present.
During self-setting, the safety edge was activated.
During self-setting, the STOP input was activated.
During self-setting, a Start/Pedestrian/Open/Close input was acti-
vated.
dIAGNOSTICS
WASTE dISPOSAL
SWO-M1 SWO-M2
SWC-M1 SWC-M2
P.P. PED OPEN
PHOT-O STOP
PHOT-C
DAS
CLOSE
19