Adjustments - Pattfield PE-20 DDB Traduction De La Notice Originale

ATTACH BATTERY
1 Slide the battery 7 onto the tool until it
clicks into place.
Caution! Only use the tool with the
batteries specified in technical data.
FIT BIT
1 Open the chuck ring 1 until the bit fits
into the chuck.
Caution! Before changing bits, cen-
tre the rotation direction switch, in
order to lock the tool.
FIT DRILL
1 Open the chuck ring 1 until the drill
fits into the chuck and set the torque
ring 10 to drill .
Caution! Before changing drills,
centre the rotation direction switch,
in order to lock the tool.
ROTATION DIRECTION
1 To drive in screws or drill, set the rota-
tion direction switch 9 to
.
Caution! Wait until the chuck has
stopped rotating before changing
the rotation direction.
ROTATION SPEED
1 Set the desired rotation speed on the
gear selector 11.
1 st gear: Screw driving /
Larger diameter drilling

Adjustments

148 EN
2 To release the battery, press the bat-
tery release switch 6 and slide off the
battery.
2 Fit the bit into the chuck 2 and tighten
the chuck ring 1 securely. Set the de-
sired torque at the torque ring 10.
Remove the bit by opening the chuck
ring 1.
2 Fit the drill into the chuck 2 and tighten
the chuck ring 1 securely.
Remove the drill by opening the chuck
ring 1.
2 To loosen screws, set the rotation di-
rection switch 9 to
.
2 2 gear: Smaller diameter drilling
nd
1
1
1
1
1
2
1.
2.
2
2
2
2