Publicité
Les langues disponibles
Les langues disponibles
Installation Guide
Verify battery function
It is important to test the battery to ensure that the time and date will be retained should a power
failure occur. The following procedure will verify the battery is functioning correctly:
1.
After receiving time and date from the TouchPRO Wireless® thermostat, remove the thermostat
from the wallplate.
2.
Wait 10 seconds and replace the thermostat.
3.
After a few seconds the thermostat should return to its normal display. If it does, you are done.
4.
Remove the battery tray, adjust the metal tabs for good contact and verify battery polarity.
5.
Re-install battery tray and repeat steps 1, 2 and 3.
6.
If battery function cannot be verified, replace battery. If thermostat does not return to its normal
display, do not install the thermostat. Return it for evaluation.
Installer setup
Press SYSTEM.
1.
SYSTEM
SUN
HEAT
M33008
TUE
70
Inside
Function
0170
DONE
Press
to select
pq
function
P/N 041-338 Rev. C
2.
Press and hold
these two buttons
until the display
changes.
3.
Change settings as
required (see pages
7-9).
Setting
1
M33028
Press
to
pq
change setting
SYSTEM
HEAT
6:00
Inside
DONE
0170
DONE
Inside
0170
DONE
Press DONE to save & exit settings.
6
TUE
aM
TUE
70
TUE
70
69-2655EFS—05
CANCEL
M33027
1
M33028
1
M33029
Publicité
