Honeywell LUTRON TouchPRO Wireless Guide D'installation page 12

Installation Guide
Adding the thermostat to a Lutron® system
Programming by a Lutron® Factory Trained Installer
For full functionality, the HVAC Controller must be programmed to a Repeater and PC software
must be used by a Lutron factory-trained installer. For questions on how to become a qualified
installer, please contact your local Lutron representative.
To add the thermostat to a Lutron® system:
Use the Lutron® PC software to start activation
mode. When a Lutron® system is in activation mode,
an unaddressed thermostat will show "Device Is
Unaddressed" at the top of the screen.
To activate thermostat press MORE.
1.
The thermostat will now show the connection screen and
display "Press Connect" at the top of the screen.
Press the CONNECT button. The CONNECT button will
2.
blink and the thermostat will display "Addressing" at
the top of the screen.
3. Return to the Lutron® software and confirm
thermostat activation. When activated, the
thermostat will exit the connect screen and display
"Device Is Addressed" at the top of the screen.
4. The thermostat is now activated.
Note: The More button will disappear once the thermostat
is addressed to a Lutron® system.
Note: Use ISU setting 900 to remove the thermostat from
the Lutron® system. See page 10.
P/N 041-338 Rev. C
CONNECT
12
PM
MORE
NO SIGNAL
PM
69-2655EFS—05
M33049
EXIT
M33050
M33051