Package, Transport, Storage; Delivery; Transport; Storage - Homa H501 Manuel D'instructions Original

Automatic float switch (version...A)
Version with automatic float switch HOMA Nivomatik, AS
floater, 10 meter connection cable, switchgear and manu-
al-0-auto switch. The single phase pumps are furthermore
provided with integrated condensers and connector. The
three phase pumps are provided with a CEE reversing
plug for rotational direction
Motor cooling
Sufficient motor cooling is also provided for in snore op-
eration due to the water jacket with pressure connection
on top.
3.3.4. Pump casing
The pump casing is available with different pressure dis-
charges, depending on version and engine variation. This
creates an optimal connection to the various types of
pipework.
The pumps H501 to H506 are provided with a BSP 1 1/2"
F pressure connection, whilst the pumps H508 to H511
are provided with a BSP 2" F pressure connection.
3.3.5. Impeller
The impeller is fixed on the engine shaft which powers
it. The impeller is an open multi-channel impeller, for
drainage water containing soft solids up to 10 mm.

4. Package, Transport, Storage

4.1. Delivery

On arrival, the delivered items must be inspected for da-
mage and a check made that all parts are present. If any
parts are damaged or missing, the transport company or
the manufacturer must be informed on the day of delivery.
Any claim made at a later date will be deemed invalid.
Damage to parts must be noted on the delivery or freight
documentation.

4.2. Transport

Only the appropriate and approved fastening devices,
transportation means and lifting equipment may be used.
These must have sufficient load bearing capacity to ensu-
re that the product can be transported safety. If chains are
used they must be secured against slipping.
The personnel must be qualified for the tasks and must
follow all applicable national safety regulations during the
work.
The product is delivered by the manufacturer/shipping
agency in suitable packaging. This normally precludes the
possibility of damage occurring during transport and sto-
rage. The packaging should be stored in a safe place if the
location used is changed frequently.

4.3. Storage

Newly supplied products are prepared that they can be
stored for 1 year. The product should be cleaned thoroug-
hly before interim storage.
The following should be taken into consideration for sto-
rage:
• Place the product on a firm surface and secure it
against falling over. Submersible mixers and auxiliary
lifting devices should be stored horizontally, submer-
sible sewage pumps and submersible motor pumps
should be stored horizontally or vertically. It should be
ensured that they cannot bend if stored horizontally.
Danger from falling over!
Never put down the product unsecured. If the
product falls over, injury can occur!
• The product has to be stored at a place free from vi-
brations and agitation to avoid damage from the ball
bearings.
• It is also necessary to pay attention to the storage.
The device should be stored in dry rooms without
temperature fluctuation.
• The product may not be stored in rooms where wel-
ding work is conducted as the resulting gases and ra-
diation can damage the elastomer parts and coatings.
• It is responsible to take care that the corrosion coa-
ting will not be spoiled
• Any suction or pressure connections on products
should be closed tightly before storage to prevent
impurities.
• The power supply cables should be protected against
kinking, damage and moisture.
EngliSH | 27