Design Guide - Standard Installation
Refrigerator
Top View
130° DOOR SWING
Scale 1:1
IMPORTANT NOTE –
FOR DISPENSER MODELS:
Dispenser models are supplied with two
dispenser trims, one to fit framed panels
and one for overlay panels. Dispenser
trim fit to the custom panel depends on
correct panel thickness. Framed panels
must be 1/4" (0.63 cm) nominal. Overlay
panels should be constructed as shown
to accomplish a total 1.100" (2.79 cm)
thickness.
See page 13 for details.
23-7/8" From
Rear of
Refrigerator
1"
Case
3/4"
Trim
1/2"
1-1/2"
1/4"
1-1/4"
Door
12
Frameless Cabinets: The case trim
overlaps cabinets at the top and sides.
Therefore, frameless cabinets may require
filler strips to prevent interference with
cabinet door swing. The opening must
allow for filler strips.
2"
3"
1-3/4"
2-3/4"
2-1/2"
2-1/4"
1/4"
1/2"
3/4"
3/4" Overlay
Panel
(Nominal Size)
1/4"
1/2"
3/4"
1"
1"
1-1/4"
31-1000450 Rev. 1