Installation Instructions - Standard Installation
STEP 6 ANTI-TIP PROCEDURE (Cont.)
ADVERTENCIA
Estos refrigeradores son inestables, especialmente
cuando una puerta se encuentre abierta, y deberán estar
asegurados a fin de evitar caídas hacia adelante que
podrían resultar en la muerte o en lesiones graves. Lea y
siga las instrucciones de instalación en su totalidad para
asegurar el refrigerador con el sistema anti volcaduras.
• Cut a 2" x 4" block, 35" (88.9 cm) long and secure the
block to the mounting brackets provided using #12 or
#14 wood screws.
• Secure the bracket
with wood block to
the back wall so
that it is 84" (213.36
cm) from the
finished floor. Use
#12 or #14 wood
screws. See the
illustration.
• The screws must
penetrate at least
one inch into the
vertical wall studs.
• If metal wall studs, use self-tapping sheet metal
screws in place of wood screws.
IMPORTANT: When the refrigerator is installed under
a soffit or if there is not enough height for this method
of security, brackets cannot be used. Proceed to step
7 to level the refrigerator and then to step 8 to secure
refrigerator to cabinets.
The refrigerator must be
secured to prevent tipping.
Riesgo de Caídas
18
STEP 6 ANTI-TIP PROCEDURE (Cont.)
Connect Power Cord:
• Before pushing the refrigerator into the opening, plug
the power cord into the receptacle. The water filter
guard will need to be removed for access (some
models). Remove the 3 screws holding it in place. If
access is still too tight, remove the 2 screws holding
the water filter bracket and move aside. Open the
grille panel and reach into the opening at the back
to grasp the power cord. Pull the power cord into the
opening as you push the refrigerator back. Secure
the bracket and guard with the original screws.
• Gently push refrigerator into the opening with hands
against front corners.
31-1000450 Rev. 1