Table des Matières
Publicité
- Press and hold key 4 for approx. 2 seconds; both LEDs flash
- Press and hold key 4 for approx. two seconds again and the memory space will be clea-
red. An acoustic confirmation sounds and the LEDs go out
- To exit the menu item, press key 3
4. Level 1 - Resetting to factory settings (factory reset)
- Aim: you want to clear the drive settings. There are three options to choose from: I.) Clearing the
programming for your window and any other settings on the advanced menu (see 5.). II.) Clearing
all saved transmitters. III.) Complete factory reset
- Press keys 1 + 2 simultaneously, after a short time LED1 turns green.
- Press key 2 twice in succession; LED1 turns red.
- Confirm your intention to carry out a factory reset by pressing key 4
- LED1 is red, LED2 is green = option I. This position resets the programming process and
all settings on the advanced menu
- Pressing key 1 or 2 switches to option II or option III: LED1 is red, LED2 is yellow = option
II. This position clears all transmitters (remote controls, keypad).
LED1 is red, LED2 is red = option III. This position triggers a complete factory reset. The
drive is then in its delivered condition
- With the LED display required, press and hold key 4 for approx. 2 seconds; both LEDs
flash alternately
- Press and hold key 4 again for approx. 2 seconds and the reset is carried out. An
acoustic confirmation follows and the LEDs go out.
- To exit the menu item, press key 3
5. Level 2 - Advanced menu settings
The settings on the advanced menu are optional. You can modify the default values for the drive
on three submenus: A) Signal tones, B) Torque and C) Tilt function.
To access level 2, first complete the following two steps:
- Press keys 1 + 2 simultaneously, after a short time LED1 turns green.
- Press keys 1 + 2 simultaneously again, after a short time LED1 flashes green.
A) Signal tones (LED 1 flashes green)
- Confirm your intention to change the signal tones by pressing key 4
- Choose the required setting by pressing key 1 or 2:
LED 1 green / LED 2 green: signal tone in all end positions (factory setting)
LED 1 flashes green / LED 2 lights yellow: signal tone on motorised locking
LED 1 flashes green / LED 2 lights red: no signal tones*
* Alarm signals for required battery change, overload of the drive and magnetic displacement
(attempt at burglary) and key tones for the drive cannot be switched
off!
B) Torque
- Switch to this menu item by pressing key 2. LED1 flashes yellow
- Confirm your intention to change the torque by pressing key 4
- Choose the required setting by pressing key 1 or 2:
LED 1 flashes yellow / LED 2 lights green: torque restriction set (ca. 6 Nm).
LED 1 flashes yellow / LED 2 lights red: maximum torque (ca. 8 Nm)
32
Publicité
Table des Matières
