Table des Matières
Publicité
General information
- Use the ABUS Home Tec Pro CFF3000 remote control / ABUS Home Tec Pro CFT3000 keypad (available
separately) for all menu items except 1
- Programming of the drive is carried out on two levels.
Level 1: Programming and clearing of remote control(s) and keypad, and factory reset.
Level 2: Advanced menu for setting signal tones, torque of the drive and activation of tilt function
- Always scroll through a menu with keys 1 and 2, cancel a function with key 3 and confirm a
function with key 4.
- Every button press is confirmed by a signal tone: a sustained tone as a confirmation/acknowledge-
ment; a double tone as an erroneous or impermissible button press.
- You can find an overview of the program structure and the assignment table under 7., page 47, 52.
1. Level 1 - Programming the drive
- Aim: programming of the drive for your window is required on initial commissioning and after
a factory reset
- Starting position: window handle is in "closed" position, but the cylinder must be unlocked
- Press keys 1 + 2 simultaneously, after a short time both LEDs flash yellow
- Confirm "closed" position by pressing key 4; a long signal tone sounds
- Turn the handle to "open" position
- Confirm "open" position by pressing key 4; a long signal tone sounds
- Turn the handle back to "closed" position. When the position is reached, a long signal
tone sounds
- The wireless window drive is now programmed for the window and the two LEDs go out
- Possible error message: if a position is not detected, instead of a long tone, a double tone sounds.
Move the window handle to the correct position and confirm it again.
2. Level 1 - Programming of remote control(s) and keypad
- Aim: programming of transmitters so that you can operate the drive conveniently with the
remote control / keypad. You have the option to set up a maximum of 9 transmitters. If all memory
locations are occupied, you can only open this menu item after deleting min. 1 transmitter.
- Starting position: the drive must have been programmed for the window (see menu 1)
- Press keys 1 + 2 simultaneously, after a short time LED1 turns green
- Confirm the programming process by pressing key 4; both LEDs flash. In delivered state,
the first free memory space is indicated by the colour combination green / green.
If transmitters have already been programmed, the next free memory space is displayed
(colour combination green / yellow, then green / red, and so on, see configuration table
>> 7., page 50).
- Now confirm the remote control / keypad to be programmed (see instructions CFF / CFT).
If programming is successful, a sustained tone sounds and the LEDs indicate the next free
memory space.
- To exit the menu item, press key 3.
3. Level 1 - Clearing remote control(s) and keypad
- Aim: you want to clear a programmed transmitter, e.g. because the remote control has been lost
- Press keys 1 + 2 simultaneously, after a short time LED1 turns green
- Press key 2; LED1 turns yellow
- Confirm your intention to clear the transmitter by pressing key 4
- The first assigned memory space is displayed (colour combination green / green). If more
than one memory space has been assigned and you wish to clear one of them, switch to
the required space by pressing key 1 or 2
31
Publicité
Table des Matières
