General Use - Klarstein LAUSANNE VERTICAL Mode D'emploi

EN
20

GENERAL USE

Note: The appliance can be operated either by the switches located on the right hand
side of the fire or by the supplied remote control.
Manual Operation
• This is done by operating the switches located on the right hand side of the fire. The
standby rocker switch must first be switched on, the fire will beep to indicate that it
is powered up.
• Press the O/I button once to turn on the appliance and fire effect. A red indicator
light will show to indicate that the fire is ON. Press the O/I button for 3 seconds this
will operate the dimmer mode, hold the button down until the desired brightness is
obtained.
• Press once the 1000W button for the low heat settings; press twice to switch off the
heat setting.
• Press once the 2000W button for the high heat settings; press twice to switch off the
heat setting.
Remote Operation
The standby rocker switch located at the right hand
side of the fire must first be switched on; the fire will
beep to indicate that it is powered up.
It takes a little time for the receiver to respond to the
transmitter. Do not press the buttons more than once
within two seconds for the fire to operate normally.