General Use; Manual Operation - Klarstein 10031557 Mode D'emploi

EN
20

GENERAL USE

Note: The appliance can be operated either by the switches located on the right hand
side of the fire or by the supplied remote control.

Manual Operation

• This is done by operating the switches located at the top right hand side of the fire.
The standby rocker switch must first be switched on, the fire will beep to indicate that
it is powered up.
• Press the O/I button once to turn on the appliance and fire effect. A red indicator
light will show to indicate that the fire is ON. Press the O/I button for 3 seconds this
will operate the flame colour setting. Hold the button down until the desired colour
is obtained.
• Press once the 900W button for the low heat settings; press twice to switch off the
heat setting.
• Press once the 1800W button for the high heat settings; press twice to switch off the
heat setting.
Remote Operation
The standby rocker switch located at the right hand side of the
fire must first be switched on; the fire will beep to indicate that
it is powered up.
It takes a little time for the receiver to respond to the transmitter.
Do not press the buttons more than once within two seconds
for the fire to operate normally.