Petsafe stubborn dog in-ground fence Manuel D'utilisation Et De Dressage page 18

To assure a proper fit, please follow these steps:
1. Make sure that the battery is not installed in the Receiver Collar.
2. Start with your pet standing comfortably (9A).
3. Place the Receiver Collar on your pet so that the "PetSafe" logo is facing your pet's
chin. Center the Contact Points underneath your pet's neck, touching the skin.
4. The Receiver Collar should fit snugly, yet loose enough to allow one finger to fit between a
contact point and your pet's neck (9B). Allow your pet to wear the collar for several minutes
then recheck the fit. Check the fit again as your pet becomes more
comfortable with the Receiver Collar.
5. Once you are satisfied with the fit of the Receiver Collar then you may
trim any excess collar strap as follows (9C):
a. Mark the desired length of the Receiver Collar with a pen. Allow for
growth if your pet is young or grows a thick winter coat.
b. Remove the Receiver Collar from your pet and cut off the excess.
c. Before placing the Receiver Collar back onto your pet, seal the edge of
the cut collar by applying a flame along the frayed edge.
To Re-Thread the Collar
Ridges
18
Slide Buckle
The slide buckle prevents the collar from becoming
loose around your pet's neck.
The ridges must be facing up; the collar will slip if it is
not properly threaded.
1-800-732-2677
9A
9B
9C