Quick Start; Status Indicator Display; Delay Timer Indicator Flow - LEGRAND L2EVSE30 Guide De L'utilisateur

Quick Start

(continued)
3. If your charging station is ready to charge, connect the charge connector to the
vehicle's charge port receptacle. While the vehicle is connected, the charge
status indicator light will flash. Once the vehicle has been fully charged, the
charging will automatically stop. If necessary, charging may be stopped before
the vehicle is completely charged.
4. To stop charging, disconnect the vehicle plug and place it back in the charging
station (Figure 2).
The charging station is equipped with a delayed start option that allows the
startup of the charging to be delayed so the vehicle can be charged during
off-peak hours. Select desired delay time by pressing the delay timing button.
Change time by pressing again. Press stop button to cancel delay. Remove and
re-insert charge plug into vehicle to restart charge sequence (see delay indicator
chart on page 4).

Status Indicator Display

The charging station has a status indicator display as shown below.
FRONT PANEL LED BEHAVIOR DESCRIPTION
Off
Solid on
Flashing
Solid on
Flashing on
Figure 2
DEFINITION
Power is off.
Use the switch on the side of the charger
to turn on the power.
Charger is turned on.
Connect the charging cable to start
charging.
Charging in process
Charger is faulty.
Please stop using the charger and
immediately contact Legrand tech support.
Charger is recovering from a minor failure.
Please stop using the charger until the
LED turns solid green.
3

Delay Timer Indicator Flow

FRONT PANEL DELAY TIMER LED BEHAVIOR
4HR 6HR 8HR
2HR
4HR 6HR 8HR
2HR
4HR 6HR 8HR
2HR
4HR 6HR 8HR
2HR
4HR 6HR 8HR
2HR
4HR 6HR 8HR
2HR
4HR 6HR 8HR
2HR
4HR 6HR 8HR
2HR
4HR 6HR 8HR
2HR
4HR 6HR 8HR
2HR
DESCRIPTION DEFINITION
4 LEDs off Delay Timer is not enabled.
The charger is ready and the
4 LEDs flashing on
delay timer can be set.
2HR LED solid on Delay Timer is set to 2 hours
2HR and 4HR
Delay Timer is set to 4 hours
LEDs solid on
2HR, 4HR, and
Delay Timer is set to 6 hours
6HR LEDs solid on
2HR, 4HR, 6HR,
and 8HR LEDs Delay Timer is set to 8 hours
solid on
Delay charging is enabled.
2HR LED flashing
Current delay time is less than 2
on
hours.
2HR LED solid on
Delay charging is enabled.
and 4HR LED
Current delay time is 2 - 4 hours.
flashing on
2HR and 4HR
Delay charging is enabled.
LEDs solid on,
6HR LED flashing
Current delay time is 4 - 6 hours.
on
2HR, 4HR, and
Delay charging is enabled.
6HR LEDs solid
on, 8HR LED
Current delay time is 6 - 8 hours.
flashing on
4