5s after the last brief pressure, the
BOOST programme is enabled.
The BOOST LED stops flashing.
The duration LEDS start the
countdown to indicate the time left.
The BOOST LED is steady red as
long as the device warms up.
The ON/OFF LED is steady red
as long as the heated towel rail
resistance is enabled.
Press the BOOST button to end the BOOST programme before the period specified.
DRYER mode
In the DRYER mode the fan runs at full speed and the resistance of the device is enabled. The tow-
el dryer continues to function, with the remote control settings. Then, if the setting is higher than
the ambient temperature, the towel warmer heats (ON/OFF LED red). If, however, the setting is
lower than the ambient temperature, the towel warmer does not heat (ON/OFF LED red). The
maximum room temperature is 39°. The DRYER mode is the highest priority and can be enabled
from any mode (except when the device is switched off).
39°C
SETTING
HEATED TOWEL RAIL
Programming the DRYER mode:
Press the DRYER button briefly.
2h 60
30
15
2h 60
2h 60
30
min
30
30
15
15
Increase temperature by using the maximum
fan speed device until the maximum temperature
of 39°C is reached and use the heated towel rail
until the set-point temperature is reached.
DRYER
[ 40 - EN ]
5 sec
2h 60
15
min
30
15