Weller WX 1011 Mode D'emploi page 19

Parameter menu
Robot output
The robot output is on the back of the device.
WX 1: OFF - ON - ZeroSmog - Stop&Go
WX 2 / WXD 2: OFF- Left - Right - Left & Right - ZeroSmog - Stop&Go
Option Description
Left Left tool channel (factory setting)
Right Right tool channel
Left & Right Both tool channels
ZeroSmog The rear floating switching output is closed when a tool is in use. Selected Zero Smog
extraction systems can be connected using an optional adaptor (WX HUB). The rear
RS 232 port continues to be functional.
Switching output is open in the Standby, AUTO-OFF or OFF positions, or if no tool is
inserted.
Stop&Go The rear RS232 port is used to drive an optotransmitter so that a KHE/KHP can be
activated via an optical fibre.
The output is activated when a tool is used. In addition, the floating switched output is
closed. The output is OFF in the Standby, AUTO-OFF or OFF positions, or if no tool is
inserted.
Footswitch (WXD 2 only + WXA 2)
In order to prevent the pump from starting pre-
maturely or to ensure a defined soldering-joint
preheating time, it is possible to set an ON delay.
Option Description
OFF Footswitch is off
ON Footswitch is on The front RS232 port is configured as a foot switch input for activating
the air flow.
Connecting auxiliary devices
Please observe the overview diagrams.
Auxiliary devices can be connected either to the
port on the front panel and/or to the port on the
back of the Soldering Station.
The Soldering Station detects automatically which
auxiliary device is connected. The Soldering Sta-
tion shows the symbol or name of the connected
auxiliary device on the front port or rear port.
Notice
If the robot is at working temperature, the display will show – ok –. Not
available with Zero Smog + Stop&Go
Setting the parameters of auxiliary devices
1. Select the auxiliary device using the auxiliary
device key (front/back).
The variable parameters (e.g. speed) are dis-
played.
2. Set the required value using the turn-and-click
wheel.
3. Confirm the value with the Enter key
Open Menu Station parameters
Station parameters
Open Menu
37