Changing The Saw Blade; Replacing The Table Insert - Altrad Lescha CPHL Serie Notice Originale

Take care that the saw blade remain free of rust and resin.
Resin residues must be removed from the table board.
Resin residues can be removed with a commercial maintenance
and care spray.
The saw blade is a wearing part and will become dull after prolonged or
frequent use.
Renew the saw blade or have it sharpened
Maintenance

Changing the saw blade

Remove the mains plug before changing the saw
blade.
Danger of cutting! The saw blade is massive and it could be to slick.
Wear gloves when replacing the saw blade.
Do not use any saw blades made of HSS steel.
Do not use any cracked saw blades or such that have changed their
shape.
Saw blades the body of which is broken must be discarded (no repair
allowed).
Only use well-sharpened saw blades.
Regrinding (sharpening) of saw blades is only allowed to be done by
qualified personnel. In particular note the following: Make sure that the
requirements for balancing of the tools according to EN 847-
1:2005+A1:2007 6.2.3.2 are met.
Danger of burning! The saw blade is still hot shortly after cutting.
1. Loosen the screws of the table insert (5).
2. Lift the safety guard (15).
3. Lift the table insert (5) and push it to the rear side. The safety guard
automatically remains in that position.
4. Insert rod (32) into motor-shaft and unscrew bolt (
.
left-hand-thread)
5. Now, the front saw blade flange (26) and the saw blade (25) can be
removed.
6. Clean the saw blade flanges.
7. Install a new or sharpened saw blade.
Pay attention to the correct running direction of the saw blade: The
arrow on the saw blade and the arrow on the protective cover must point
in the same direction!
8. Position the front saw blade flange again.
9. Re-tighten the clamping nut (27).
10. Secure the table insert.
11. The stop screw (F) must not be removed.
Replacing the table insert (Fig. 13)
Disconnect the mains plug before changing the
table insert.
Immediately replace a worn or damaged table insert.
1. Loosen the screws of the table insert (5).
2. Lift the safety guard (15).
3. Lift the table insert (5) and push it to the rear side. The safety guard
automatically remains in that position.
4. Remove the 2 nuts (E) and remove the splitting wedge (11) together with
the safety guard.
5. Install a new table insert (5).
6. Secure the blade guard with the safety guard (for blade guard adjustment
see figure 15).
7. Secure the table insert.
8. The stop screw (F) must not be removed.
Blade guard adjustments
The adjustment of the blade guard must be checked after each saw blade
and table insert change.
18