Working With The Saw - Altrad Lescha CPHL Serie Notice Originale

Only one LED is on:
1) One phase has failed: Have the supply line checked immediately by an
electrician.
2) LED module (361642) defective: Have it replaced immediately by an
electrician.

Working with the saw

You may not start to operate the machine until you have read these
operating instructions, observed all the instructions given and installed
the machine as described!
Before making adjustments to the saw settings (e.g. replacing the saw
blade etc.)
− switch off device
− wait for standstill of the saw blade.
− pull out power plug
Also, note the following important points:
Place yourself outside of the area of danger.
Cut through the piece with uniform pressure.
Never remove loose splinters, chips and the like with the hands. Make
sure that the saw blade stands still before removing such material.
At any case pay attention to all safety instructions.
Working instructions
Handle for push block
The handle for the push block
(35) is screwed to a matching
board. It is used for safe
guidance of relatively small
workpieces.
The board should be 300 to 400
mm long, 80 to 100 mm wide and
15 to 20 mm thick.
The push block handle must be
replaced if damaged.
The parallel stop can be adjusted
in arrow direction.
It is secured by the machine knob (16).
Read the scale on location (A).
Folding down the longitudinal stop
Loosen the machine knob (16).
Adjust the longitudinal stop to approx. 190mm.
Tighten the machine knob (16) again.
Fold down the longitudinal stop.
Folding out the table extension
Fold up the table extension. Move the table extension in arrow direction and
lower it. Make sure that the table extension is correctly hooked.
Cutting solid wood lengthwise
Parallel stop as stop for cross cuts
16