Maintenance And Cleaning; Exchange Of Saw Blade; Changing The Saw Blade - Altrad Lescha TSL Série Notice Originale

Using the push stick
Using the movable cross stop
Handle for push block
The handle for the push
block (69) is screwed to a
matching board. It is used for
safe guidance of relatively
small workpieces.
The board should be 300 to
400 mm long, 80 to 100 mm
wide and 15 to 20 mm thick.
The push block handle must
be replaced if damaged.

Maintenance and cleaning

Before each maintenance and cleaning work
Switch off device
−
Wait for standstill of the saw blade
−
Pull out mains plug
−
Maintenance and repair work other than those described in this
chapter is only allowed to be carried out by service staff.
Safety devices removed for maintenance and cleaning must be
unconditionally remounted properly and inspected.
Only use genuine spare parts. Other parts may result in
unpredictable damages and injury.
Cleaning
Observe the following to maintain the operability of the machine:
Do not hose down the device with water.
Remove shavings and dust only with a brush or vacuum
cleaner.
Regularly clean and oil all movable parts.
Never use any grease!
Use for instance sewing machine oil, liquid hydraulic
fluid or environmentally acceptable spray oil.
Always keep the motor's cooling ribs clean to ensure
adequate cooling.
Take care that the saw blade remains free of rust and resin.
Remove resin residues from the table plate surfaces.
Resin residues can be removed with a commercial
maintenance and care spray.
The saw blade is a wearing part and will become dull after
prolonged or frequent use.
Renew the saw blade or have it sharpened.
Maintenance

Changing the saw blade

Remove the mains plug before changing the saw
blade.
Danger of cutting! The saw blade is heavy and it could be
slippery. Wear gloves when replacing the saw blade.
Do not use any saw blades made of HSS steel.
Do not use any cracked saw blades or such that have
changed their shape.
Saw blades the body of which is broken must be discarded
(no repair allowed).
Only use well-sharpened saw blades.
Regrinding (sharpening) of saw blades is only allowed to be
done by qualified personnel. In particular note the following:
Make sure that the requirements for balancing of the tools
according to EN 847-1:2005+A1:2007 6.2.3.2 are met.
Danger of burning! The saw blade is still hot shortly after
cutting.
Changing the saw blade
Remove blade guard.
16