Maintenance And Cleaning - Altrad Lescha CPHL Serie Notice Originale

Cutting wedges using the wedge cutting stop
Using the pushstick
Using the movable cross stop
Adjusting the cutting height
The cutting height is adjusted with the handwheel (B). The cutting height can
be continuously adjusted as desired.
17
Connecting a chip extractor
Chip ejector slot closed (operation with chip extractor)
A chip extractor can be connected to the saw to extract the chips. (Diameter
of extractor nozzle: 100 mm.) Close the sealing blade on the chip ejector slot
and secure it using the machine knob.
Chip ejector slot open (operation without chip extractor)

Maintenance and cleaning

Before each maintenance and cleaning work
− Switch off device
− Wait unitl the saw blade comes to a stop.
− Pull out power plug
Maintenance and repair work other than those described in this chapter is
only allowed to be carried out by service staff.
For maintaining and cleaning, removed security devices must unconditionally
be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected damages and
injuries.
Cleaning
Observe the following to maintain the operability of the machine:
Do not wash down device with water.
Remove shavings and dust only with a brush or vacuum cleaner.
Regularly clean and oil all movable parts (e.g. fasteners of the guard).
Fig. 10
Never use any grease!
Use for instance sewing machine oil, liquid hydraulic fluid or
environmentally acceptable spray oil.