Working With The Saw; Motor Protection; Height Adjustment; Work Instructions - Altrad Lescha TSL Série Notice Originale

Power system impedance
In case of disadvantageous power system conditions short-term
voltage reductions can occur during the starting process of the
device which can influence other devices (e.g. jittering of a lamp).
No breakdowns are to be expected if the maximum, electrical
mains supply impedances given in the table are met.
Power input P (W)
1
230 V~ 2.0 kW
230 V~ 3.0 kW
400 V 3~ 3.3 kW
On/Off switch
Switching on
⇒ Press the top green button of the switch.
The device cuts off automatically in case of power failure. To
restart, press the green button again.
Switching off
⇒ Press the bottom red button.

Working with the saw

You may not start to operate the machine until you have
read these operating instructions, observed all the
instructions given and installed the machine as described!
Before making adjustments to the saw settings (e.g.
replacing the saw blade etc.)
− Switch off device.
− Wait for standstill of the saw blade
− Pull out mains plug.
Also, note the following important points:
Place yourself outside of the area of danger.
Cut through the piece with uniform pressure.
Never remove loose splinters, chips and the like with the
hands. Make sure that the saw blade stands still before
removing such material.
Observe all safety instructions in any case.

Motor protection

The motor is fitted with a protective switch which automatically
switches off the motor when it is overloaded. The motor can only
be switched on again after it has cooled down.

Height adjustment

The required cutting depth is adjusted with the crank (5).
Power system impedance Z
max
0.07
0.07
0.13
Bevel cut adjustment
Release the two star grip screws (11).
Adjust the required cutting angle.
Hold the adjusted position.
Tighten the two star grip screws.
(Ω)
Concealed cuts
Use a normal splitting wedge in conformity with DIN 38 820
(accessory – order-no. 360115).
Using the table extension
If a second person works with you on the saw he/she must
be standing at the take away end of the table extension.

Work instructions

The parallel stop can be adjusted in arrow direction.
The longitudinal stop is locked in place by the machine knob (5).
Cutting solid wood lengthwise
15